(0)
£0.00 inc. VAT
Universal Wall Starter Kit (Stainless Steel)
Hover over image to zoom.

Universal Wall Starter Kit (Stainless Steel)

code: n/a
From £13.49 inc. VAT (FREE UK Delivery)
Item in Stock  |  Usually dispatched within 24 hours
Add to Bag
This product has been added to your basket...
  • Continue Shopping
  • Checkout

  • Universal Wall Starter Kit / Wall Extension Profiles
  • Wall heights up to 2.4m per pack.
  • Masonry widths 60mm to 250mm BBA Approved for up to 8m.
  • Unique built in ties simply "snap out" of the profile.
  • Fully adjustable for easy positioning.
  • Just slide and fit ties for easy and accurate alignment.
  • Fixing and instructions included.
  • Available as 1 Single Tie or 10pk

  • Universal Wall Starter Kit / Wall Extension Profiles
  • Wall heights up to 2.4m per pack. (8feet)
  • Masonry widths 60mm to 250mm BBA Approved for up to 8m.
  • Unique built in ties simply "snap out" of the profile.
  • Fully adjustable for easy positioning.
  • Just slide and fit ties for easy and accurate alignment.
  • Fixing and instructions included.
  • CONTENTS:
  • 2 x 1.2m Profiles.
  • 10 x "Snap Out" Ties
  • 5 x Fixing Sets.
  • FIXING INSTRUCTIONS
  • Ensure existing wall is sound and clean to ensure connector has direct contact with existing masonry.
  • Locate the first channel above DPC level at centre point of the new masonry to be constructed.
  • Plumb the section marking the fixing holes, then drill and plug the existing wall.
  • Lightly screw the first channel then slot the upper channel into the lower section and plumb mark and drill the remaining fixing points.
  • Align both connectors then tighten all coach fixing screws.
  • Lay bricks or blocks for the new wall in conventional way. Be sure to bed them with mortar against the starter.
  • Install the turn and slide ties into the channel, spacing them at 300mm centres. The ties should be completely surrounded with mortar.


  • IMPORTANT NOTES
  • For cavity wall construction, each leaf of the new wall requires a Trade Start wall connector.
  • For external application ensure the bottom edge of the channel is placed above existing DPC level.
  • The vertical joint between the existing wall and new walls must be completely weather sealed.
Be the first to review Universal Wall Starter Kit (Stainless Steel) . Write a review ›