Atoni Threaded Tap Connector (35mm outside of fitting measurement)
Fits the 3/4" "Farmer's Tap"
This tap connector converts a farmers 3/4" tap to accept ordinary quick connect hose fittings. It is made of brass so therefore won't rust or corrode. It comes with an o-ring in the quick connect, and a flat rubber washer inside the 3/4" side for a water tight seal.
7/8"/22mm top of connection point (where connector meets threaded base)
Note: Inside Thread measures 30mm/1.18"
Atoni Brass Tap Connector 3/4 Farmers Tap, Everything was good, I asked a question late on Thursday night, I got an answer by Friday, ordered the same day and received the item on Monday - Result
Your DIY ShopHad been searching high and low for a 7/8 bsp fitting with quick release connections for a bras tap which states 3/4 inch. That being the inlet not outlet size. Finally found this, bought one to check and immediately ordered another as does the job to a T.
Your DIY Shop
